Where the waste gate lines are, is it the two pipes off the lower turbo air feed.

Before i commit hari-cari on them

 

harve

Hi Harve,

 

Sorry I don't have a pick. Mmm what are you up to ?? Producing too much boost?

 

I am not sure how they can be opened but I hear they can be opened to allow exhaust to bypass the exhaust turbine, therefore less boost.

 

Take a loot in the Fast CD that sure tell you where it is.

 

(can you take a look at my wire mesh post, did you go down the halfords route?)

 

Thanks mate.

Harve,

 

go to the online manual and put "38" for slide 38 (Turbo section" and work your way up the slides. You should see what you want.

 

Hope this helps.

harve mate look on tt.net they have a section on how to install boost jets and good illistrations.

"T".....

George mate,

Forget car shops for the directional mesh go to an engineering suppliers, hole sheet £4.75 its even zintec coated for that enough for 4-5 cars ssshhhhhhhh lol.

Fix on bottom edge ONLY!!! as it creates a paralell upward movement should you graze a curb or 2 .

Buy a sheet then divide it its about a pound a car

You'll need a set of Oboes to get a presise cut though see same shop but go to tool rack

 

happy meshing - harve.

 

 

Tony hows it goin'.

Been to tt.net got all the info - but no pics or exact placement of pipes, can you point? Stanly-tips-clips & foot all ready.

See you in the week hopefully

Have they found your last cow yet? rare that is (steak or the skin) LOL

 

laters harve.