Me again.
Reverse lights don’t work. Checked the bulbs and the fuse by the drivers pedal, all seem fine.
So I assume it’s the reverse switch. I’ve bought a spare and tried to swap it today. What a pain that is! I failed.
So I have two questions:
Is this possible without dropping the gearbox?
I wanted to test it was definitely the switch before I went crazy getting it out, so unplugged the old one and plugged the new one in, put car in reverse and switched on ignition and then pressed the end of the switch in but it still didn’t turn the lights on. Does the switch work this way? That you can push the plunger end in and it should turn on?
By
RobHowl ·
After posting my, personal, comments on the Ecotek products on this forum, I had the following email this morning:
The comments you made on the 300zx forum seem to refer to ECOFLOW and not our product.
We spend a lot of time and money on protecting our brand image and are always disappointed when we are mistaken for products
which, as you suggest, are rather less efficacious than ours.
The Ecotek CB-26P has been quite positively reviewed for use with a number of Nissan engines: http://www.ecotekplc.com/more_cars_6.htm#primera
Regards,
Barclay
Ecotek Technologies Plc. www.ecotekplc.com
Just be careful what you say guyz you never know who you'll get spammed by.
Let's keep the forum for 300zx enthusiasts.
Tim
[This message has been edited by TT Tim (edited 10-10-2001).]