Can any know how to fit a fuel pressure regulator?? not sure and don't want fuel P***ing out everywhere as i drive along!!

Anyone??

Why do you want to?

If there appears to be a fuel leak under it it is more likely a hardened rubber fuel pipe that is slack and leaking fuel from the high pressure fuel injector side. IIRC it is on the NS between the back 2 plenum pipes. You have to take off the middle throttle cable cover with all the Nissan 24V twin cam stuff on it to get access to all conns esp the one down to the fuel injector rail - which is the one that often leaks making the FPR look broken. It has 2 off 8mm hose connections and a push on hose and is held on with 2 - 10mm bolts. You find it by No 4 coil pack. 2nd one back RHS when stood at the front of the car facing engine.

 

Worthwhile investment is to buy some high pressure 8mm fuel hose and change every bity of hose you can find on the engine. After 10- 12 years on a hot zed they are all harder than a witches t1t.

 

Hope this helps -check the on line manual for more info

No i think you miss ubderstood, i have a new FPR and wan to make sure that i connect it right, i didn't mean that i had a fuel leak! sorry, but thanks anyway.

First Off Either Remove The Fuel Pump Relay,or Go In The Boot And Remove The Fuel Pump Cover Plate And Disconnect The Wiring Plug On The Pump,start The Engine,when It Dies,crank It Over A Couple Times,this Releives The Fuel Pressure,locate Your Fpr And With Some Rags Handy Remove Connecting Pipes[3]when Fitting The New Valve Fit New Pipe-as Willieo Says It Will Probably Be Sh@@ged!!

Refit Relay/plug If Not Already Done So,start Engine Check For Leaks :)