I've got the Snooper SLD 920 (thanks Bob) and managed to fix the two laser heads to the underside of the front vent (in the rain) but how on earth do I connect the wires from the engine bay to the cabin without removing the whole dash and engine. It's bloody tight in there. Does anyone know of an easy way to run the wires into the cabin without too much hardwork????

 

Cheers,

Van

Van - theres a couple of places, but the easiest is down in the drivers footwell.

 

Remove the drivers kick panel (2 screws in the firewall, one in the middle of the panel, remove the two front most screws from the door trim panel, and pull out), and look up into the corner.. There's a big grommet in the bulkhead that the bonnet release goes through - through there is the easiest place to take cables..

 

Have fun!

 

------------------

Az

 

[This message has been edited by aaronjb (edited 15-09-2001).]

Az, I'm not Vijay m8.

Cheers for the advice. I'll try that and let you know later how I got on.

 

Cheerz,

Van

Bwahahaha.. I see no errors in the post above? :D

 

Ahem :)

 

[This message has been edited by aaronjb (edited 15-09-2001).]

?????????????????

I'll come clean to save confusion

 

Before I edited the first post, I'd put Vijay instead of Van.. Coz I'm going a bit senile I think

 

------------------

Az

Cheers guys,

I've got it sorted. What a nightmare though.

Laters,

Van