How to remove my OSR balljoint out of its assy' ????

 

With Hi-cas...........

 

 

any tools etc.......... cheers Andy tt.

Look in the relevant section here for some help.

http://www.300zx.co.uk/cgi-bin/manual.cgi

 

(You can buy the manual on rom at ZCentre)

Lots of patience, lots of wd40 or similar & suitable size drifts, 1 to press the ball joint out and another to press it back in again (different sizes), basically two bits of pipe that fit over the ball joint. I think these are actually shown in the manual including the dimensions....

cheers;)

I put a reply to your other message further down...I have just done this on my Z. In the end I had to take the entire hub off the car because there was no way I could get anything into the space that would get it out. Once off the car it took under 15 minutes to change the ball joint....using a copper mallett to remove the old one and then an oversized socket and a vice to squeeze the new one in!!!