Jump to content

Featured Replies

Posted

Started building up my engine today from the bare block, using Nissan bearings, but the thrust bearing (crnk bearing #4) will not fit in place on either the cradle or block?

The crank is stamped 1 and block 2, so i got a grade 3 bearing as per WSM, part number matches and colour stamped properly but is just far to tight a fit and would need significant force (i.e. being hammered) into place.

Anyone had any experience of this?

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

Recently Browsing 0

  • No registered users viewing this page.

Important Information

Terms of Use