Jump to content

300ZX Owners Club

300ZX Owners Club

300ZX Owners Club

300ZX Owners Club

300ZX Owners Club

300ZX Owners Club

Existing user? Sign In
Sign In

Email Address

Password

Remember me
Not recommended on shared computers

Forgot your password?
Sign Up

99 spec bumper

Posted July 20, 20168 yr

if i was to register my interest in an oem 99 spec bumper is don't suppose anyone has one laying about do they? xD

Quote

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.

Reply to this topic...

https://www.300zx-owners.club/forums/topic/154128-99-spec-bumper/

Go to topic listing

No registered users viewing this page.

No registered users viewing this page.

Happy Birthday Chris300

Have a good one Chris. 🎂

By Gaz 300 · Posted 4 minutes ago4 min
Clutch issue after car standing for a long time..

I had a similar problem and solved it with a piece of 4 x 2 held in place by the seat overnight to depress the clutch, May have been an old wives tale to bleed the system but it worked for me

By A 2X OK · Friday at 16:161 day
Clutch issue after car standing for a long time..

Update - left it for a while and pumped the clutch repeatedly to get the pressure back up. Now changing into all gears again 🥰
Next job is to swap out the instrument cluster for a new one and prep it for an MOT.
Then I'll just need to remember how to drive a manual again! 😂
CheerZ
Steve 🙂

By cybernet · Friday at 16:131 day
Clutch issue after car standing for a long time..

Happy Friday all!
I've finally started work on my Zed! It has sat in my garage since 2013 with only a couple of engine warm ups. The last time I turned her over was July 2023 when I discovered that my braided fuel lines had started to perish and were pissing fuel all over the engine bay. Fuel lines have now been replaced along with a new battery, oil, coolant and fuel. Pleased to report she's now starting up and idling fairly well.
However, I went to move her out of the garage for the first time today and was unable to engage reverse gear. Clutch pedal feels ok but there's more travel than I remember before it hits resistance. I've found that I can get the car in gear with the engine off, but not when it's running. An RPS Twin turbo MAX Street Clutch was fitted around 800 miles ago (in 2009!). Assuming this points to slave cylinder, but would welcome any suggestions before I start heading off down a blind alley!
CheerZ
Steve 🙂

By cybernet · Posted Friday at 12:491 day
Trip to Brands Hatch

By JaiKai · Monday at 15:515 days

Important Information

I accept