Hello all, the abs light is staying on all the time, it's bein like this since I bought the car, done the diagnostics cheak and iam getting 1 flash, right front actuator solenoid, what exactly is this? Where do I go from here? Quick replys welcome as the car is pulled apart!

Is it toped up with brake fluid?

Have you followed the diagnostic procedure 6 in the FSM?

Does this help http://www.300zx.co.uk/forums/showthread.php?153888-Abs-Tech

Ya Gary just cheaked break fluid all good. @ Andrew I checked the 3 different fuses for abs, there all fine. Done the diagnostic cheak where ya drive the car above 20 mph for 60 seconds+ and iam getting 1 flash in the abs Ecu now.

@Gary cheers bud, that's the tread I was using, il have to keep searching!

Diagnostic procedure 6 in the FSM:

 

br-47.pdf

Andrew can't get that picture to load, what's procedure 6?

Andrew can't get that picture to load

 

It loads for me from that link. What error are you getting?

Edited February 6, 201411 yr by AndrewG

Here is the link to the online FSM for that page:

 

http://www.300zx-twinturbo.com/cgi-bin/manual.cgi?list=br&dir=&config=&refresh=&slide=47&cycle=off&scale=0&design=default&total=56

 

If you don't have the FSM, then here is a link to the ABS diagnostics section for you:

 

http://www.300zx-twinturbo.com/cgi-bin/manual.cgi?list=br&dir=&config=&refresh=&slide=30&cycle=off&scale=0&design=default&total=56

Nice 1 Andrew, that's exactly what I need. Will have a go at this tomorrow and report back..

Checked this with the multimeter and getting 8 ohms between the two terminals so it looks like the control unit needs replacing, thanks for the help lads