....well tea and bacon sarnies actually :biggrin:

 

Ok, does anybody fancy helping me finish off a few jobs on my zed today (Friday)???

 

If it can be sorted in time (I'm leaving 10am sharp on Saturday) it's being used by Luke Fink in round 2 of Drift Allstars this Sunday, but needs a few things sorting to get it to comply with comp regs.

 

if you can lend a hand it would be much appreciated

 

Mobile: (07789) 488020

 

cheers

 

Pez

I would but I've got a flight to catch :D

Same here, I've got air day rehearsals all day !!!!!!!

Wish I was closer Pez, woud have been an absolute pleasure...

 

Tip.. get the gazebo up, its going to be wet....

Wish I was closer Pez, woud have been an absolute pleasure...

 

Tip.. get the gazebo up, its going to be wet....

 

Same Here :(

I would but I've got a flight to catch :D

 

Like that's an excuse :biggrin:

 

keep your head down chief

I'm too far away and probably wouldn't be that great a help anyway. Out of interest what needs doing? Would love to are the zed drifting

I was passing your way around 3am this morning too....probabaly a bit early :biggrin:

I was passing your way around 3am this morning too....probabaly a bit early :biggrin:

 

Strange you say that because I stopped tinkering at 02:45hrs this morning.

 

The rear right hub is back on now, bearing all sorted. The adjustable arms and coilovers are re-fitted and the brakes have been bolted back on.

 

Still a few bits and bobs to get sorted, I can't do it so Fink's team will have to sort it out (finish welding the cage/fit battery cut off/yet another wheel alignment etc)

 

It'll be a miracle if it does get sorted on time, either way at least it's put a rocket up my arse and got me to crack on with the jobs that have been put on the back burner for way too long now

Did you get your rear wheel to sit flush in the end mate? Just wondering if it was a problem with the grease seal?

Did you get your rear wheel to sit flush in the end mate? Just wondering if it was a problem with the grease seal?

 

I definately didn't forget to put the washer on before fitting the nut

 

but now that the washer (that I didn't forget to put on) is....uh....on, well it sits just fine :tongue_smilie: