A-pillar Blitz Gauge installed..hose run into engine bay......now where the flying fook do I connect it!!!

 

Will i need a T-piece...if so where do you get them from...............

 

Many thanks...........

 

Regardz

 

 

 

I tee-d mine in to the hose to the boost sensor (RHS of engine bay near brake servo).

 

Think halfords do tee's. If not, one of a washer jet line should do.

Any chance of pic or link to pic.....

 

I have the breather kit fit so there seems loads of pipes dont want to cut into wrong one!!!

 

Many thanks

 

 

THIS IS THE AREA YOU WANT TO LOOK AT

In (b) there is a pipe coming off(about where i show.

i cut my pipe and put the t connector in it,then my boost pipe.

you can check to see if its the right pipe first by checking if ur boost gauge(stock) stops working when ya disconnect it?

Many many many many thanks..............

 

Regardz

 

It was quite confusing on TTnet...as left hand drive....etc.......etc

 

Regardz

 

 

no probs ,hope it helped.jay

you can thank "TRAY" for the grid!

 

[This message has been edited by jaylox (edited 27-07-2002).]