Pistons and rods installed. Just waiting on a set of STDX King rod bearings to make some adjustments to my big end bearing clearances…. Unsurprisingly, the STD size bearings EPR used produced 0.0017” clearance not the 0.0035” quoted in the build sheet. Targetting 0.0025” for this build. Also reinstalled the @brettdempseyengineering oil tree. Oh and I will never use a ratchet piston ring compressor ever again, these ring compression sleeves are SOOOOO much easier to use!!
By
nickz32 ·
Had the car up on ramps today trying.to locate the hicas leak ! it seems to be coming.from the toppass side pipe at the very top...
question is are the pipes replacable if so wer from ? and wat is the best way to get at the bloody things as there right above the sframe :(