combined boost / tach gauge fitment?

Followers

February 14, 201213 yr

hey guys, im trying to fit a combined boost / rev counter. im pretty safe with the boost gauge side of it, (fit sender in to the place where it tees in. then wire through to the dash.)

but i dont know where to take the feed for the rpm? any ideas? cheers guys!

Quote

February 14, 201213 yr

Your best bet is to take it direct from the ECU tach signal at pin 7 on the connector.

HTH

Quote

February 14, 201213 yr

Author

cheers pal, ill give it a go!

Quote

February 14, 201213 yr

No worries mate, I had to do the same thing when I installed my TC.

Edited February 14, 201213 yr by Steams

Quote

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.

Reply to this topic...

Followers

Go to topic listing

No registered users viewing this page.

No registered users viewing this page.

UK TT Manual Project

Well I thought things were going too well. The underside has come up well and is looking a whole load better now.
Turns out pre 2009 cars don’t need reverse lights to work to pass an MOT, so I can solve that problem another day. (Switch is working fine, but no signal getting to the rear)
New tyres delivered yesterday and I can just run them down the local fitting shop and have them fitted.
So I thought to myself, I’ll throw on the new pads and discs tonight, and she will be ready to go!
Then the brake pipe broke from the calliper and I had a sense of humour failure.

By RobHowl · 10 hours ago10 hr
Simply Japanese at Beaulieu 19th July 2026

I was just completing my booking but realised that it’s one of my daughter’s 16th birthday! I’ll check what she’s up to and see if I can get a pass! She may come with me, but doubtful. Will update as soon as I know.
Steve 😁

By cybernet · Yesterday at 00:001 day
Check engine light comes on and off sporadic.

Those codes are all pointing at a related issue. A/F ratio falling out of range, heater elements within the O2's out of temp range, EGR sensor or exhaust gas temp falling out of range, etc. There is a few areas to consider...
Was any work recently done to the car that may have triggered this? When was the last time you replaced the O2 sensors? Check the O2 connectors and wiring to make sure one of them hasn't contacted the exhaust or melted. Any exhaust leaks especially before the cats? When was the last time you performed an induction service and cleaned the intake, TBs, IAC, etc? The EGR and IACV love to get carbon buildup over the years and can affect flow, similarly can happen to the vac lines to the factory wastegate control solenoid. You mentioned the car felt like it was still running well, so no idle RPM fumbling, hanging, stumbling, etc? Are you running an aftermarket boost control solenoid or OEM? Sorry for the load of questions, but need a bit more to go off of to help point you in the right direction.
Even though the vehicle has considerable low mileage, it's still 30 years old. If it's kept in a garage it tends to handle the elements better than sitting out in the external environmental conditions and will need more routine maintenance and care regardless if it's being driven or not. (i.e. 60K / 120k maint w/ timing belt)

By protoj · Tuesday at 18:482 days
JaiKai - MK2 - Ziggy Build

Time to clean the AC parts as i found a birds nest in it.

By JaiKai · Tuesday at 12:042 days
Check engine light comes on and off sporadic.

Hello, I have a 1996 twin turbo manual with 64k miles. I recently started having the check engine light come on sometimes and other times it doesn't. When I checked the codes these are what I got : If anyone has had these same codes what did they change to fix the problem. Car runs fine with check engine light on but want to fix issue. Any help would be greatly appreciated. Thank you.
P0400
P0136
P1150
P1155

By JB300ZXTT · Monday at 22:143 days

Sign In

combined boost / tach gauge fitment?

Featured Replies

Join the conversation

Recently Browsing 0

Recently Browsing 0

Popular Posts

UK TT Manual Project

Simply Japanese at Beaulieu 19th July 2026

Check engine light comes on and off sporadic.

JaiKai - MK2 - Ziggy Build

Check engine light comes on and off sporadic.

Important Information

Account

Navigation

Search

Configure browser push notifications

Chrome (Android)

Chrome (Desktop)

Safari (iOS 16.4+)

Safari (macOS)

Edge (Android)

Edge (Desktop)

Firefox (Android)

Firefox (Desktop)