ive tried to connect my aerial but dont no which wire it is to get my aerial to extend when i put the power on,i have a kenwood mask tape unit.

if anyone can help id appreciate it ...jay

 

its the wires behind the stereo

Any use ?

http://www.aus300zxclub.com/tech/stereo.htm

 

 

 

------------------

Z32 technical article index

YIPPEE,YIPPEE,YIPPEE,cheers m8

well ive just had a crack at it(the above help was not much good sorry to say)

ive found a spare live wire which was being used for my amp which i havnt got in the car,i'm guessing this i the live to push my aerial up,i have 1 other wire which im hoping is the right one(orange).

hopefully im getting better with electronics,weell seeee tommorow.jay

Which Kenwood did you go for? I just fitted a KDC-V7521 and an RTO amp and I am really pleased.

 

------------------

"Polished on drive"

"Dirty at 156mph"

---------------

Z first and anything else is secondary and live life a quarter mile at a time!

John Newcomb (NukeEm)

www.geocities.com/jn300zxtt

kenwood mask kdc 777r

JOHN,can you remember ya wiring when u installed ya kenwood

colours im intersted in are red(live)

yellow(live)

blue white stripe(live)

was ur blue for the aerial?and which colour went with it(orange)?????

jay

Blue is defo for the aerial. red or yellow is permanent live the other is ignition live. The orange i think is for the lights if i remember correctly, so it dims it.

BLUE - Switched live (ignition switch)

YELLOW - Battery live

BLACK/RED - Power Antenna

BLACK - Earth

 

These are the original loom colours.

As long as you get these right , just swap

the others about till you get it.

the wires i have left in car loom

orange

lime green

black red

 

BLACK/RED is live to your aeriel via a timer

 

Q Does your stereo work properly because

on my car :

ORANGE

LIGHT GREEN

both go to rear amplifier.

In other words your aeriel should work

if you connect up the BLACK/RED!

 

This may help on the Black/Red question? http://www.300zx.co.uk/forums/ubbforum/Forum1/HTML/005419.html

An old post.

Audio Wiring colour codes made easy!

Here are the colour codes

 

Ground - black

accessories - red

permanent battery - yellow

 

rear right positive - brown

rear right negative - black/red (2 of these!)

 

rear left positive - blue

rear left negative - black and white

 

front right positive - orange

front right negative - black and purple

 

front left positive - green

front left negative - black and yellow

 

Antenna - black and red (test these out because there are 2 black/red wires)

 

 

cheers Geoff,

just what i needed. jay

 

 

[This message has been edited by jaylox (edited 09-06-2002).]