well i've just bought a set of the rear subfram bushing collars from the u.s.

same as these

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=270624005429&viewitem=&sspagename=STRK%3AMEWNX%3AIT

 

no instructions with them so which way do they fit? i'm guessing the top ones go in with the raised centre (shown in photo) towards the bush and the flat surface to the car body but which way do the bottom ones go in i thought perhaps the way they are shown in the pic but on seeing the collars after they just arrived i'm not so sure

anybody know correct way for these?

the collars with the cut out go between the body and the subframe with the larger diameter against the body and the solid collars fit on the underside with the smaller diameter against the subframe

 

HTH

cheers fella knew about tops but thought bottoms may have gone other way lucky i asked

no worries, they should all fit (top and bottom) snuggly into the original bushes.

good luck dude, hope it all goes well