As she raws back into life after been four years off the road, because of engine out and rebuilt pratically ,sorry are new enternals to my tubs with 360 bearings and stagger stage step oil seals thanks to the one one the only MR SILVER BULLET and not only for sorting out my tubs but also for the advice of witch turns out i could not have done myself without.

I let her tick over for a while until she came off the slightly higher rev and setalled down to 800 revs and the temp up to norm working temp before slowly brining her up to 4000 rev at 500 intervals because i had which i think a sticky hydrallic lifter /tappet noise going on on a cylinder and it cleared.BUT my question is is there something i can do/ put in to stop that again>.?

good news on the fire up bud, im sure once the lifter has freed itself it shouldnt do it again

Jesus man, it is so hard to read your threads.....lol!!

Edited May 25, 201015 yr by AlanZ
ur is not abb. for your....

Jesus man, it is so hard to read your threads.....lol!!

 

I thought it was just me!

 

I bet its the excitement of getting his zed back running, even though I prefer mine to "roar" rather than "raw" (lol)

 

Well done all involved another zed saved.

 

Jeff TT

Thanks people , so i dont need to put anything in the oil them?

No matey. The 300 will always start very quickly and give a little tap noise, from start up. Nothing to worry about unless it continues, after start up. Jeff will confirm this i am sure.

 

Al.

and if it continues then what next

Jeff will answer that for you matey.

 

Al.

and if it continues then what next

 

jeff will answer that for you matey.

 

Al.

 

jeff?

jeff?

 

jeffTT who commmented earlier on this thread

jeffTT who commmented earlier on this thread

 

Sorry what i ment to say is ,ok jeff,If it continues or takes a long time to stop then what next?