Race Technology AP-22 Performance Meter

March 21, 200223 yr

As new Race Technology AP-22 Performance Meter for sale. New cost £193.88 from www.race-technology.com

Boxed with all original manuals and cables. Perfect condition. This is the data logging version and allows you to plot acceleration, speed vs distance or time, g-forces, bhp, 0-60 (or to any speed) times and 60-0 etc.

Now selling for only £120.

See Race Technology website for full spec.

Paul Bonnett

Quote

March 29, 200223 yr

You have mail.

------------------

Cheers

Stu

Quote

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.

Reply to this topic...

https://www.300zx-owners.club/forums/topic/11020-race-technology-ap-22-performance-meter/

Followers

Go to topic listing

No registered users viewing this page.

No registered users viewing this page.

UK TT Manual Project

So I’ve got another thread running to try and find a solution but I started the car yesterday, first time for probably about 4-6 weeks.
Started fine, seemed to have a misfire on the drivers side bank. This did seem to clear after a while of running so may have needed to clear its throat.
Had a lot of condensation out the exhaust which got more as it warmed up. Started to smell a burning smell and a bit of white smoke mixed in with the condensation.
Noticed oil in the water that was dripping out of the exhaust pipes.
Goes in bodyshop tomorrow till probably after Xmas so won’t be able to resolve and most likely out of my skill set anyway

By RobHowl · 5 hours ago5 hr
Quite Smokey and think it’s misfiring

It’s not got an MOT so was just giving it a run up to temp. Can’t go for a drive in it yet.
Definitely part of it was condensation as the exhaust tips were dripping water and it dispersed in the air very quickly. But there was a burning smell so some of it must have been smoke and then I noticed the oily water on the floor after probably 10-15 mins

By RobHowl · 5 hours ago5 hr
cranks but wont start Nissan 300zx z32 1990

On second look, the CAS does look normally positioned. I couldn’t see the right hand of the slot till I zoomed in.

By Stephen · 7 hours ago7 hr
cranks but wont start Nissan 300zx z32 1990

Check the connections around the PTU and CAS, the boots on your PTU are damaged so it wouldn’t shock me if the pins were corroded etc. You’ve changed stuff around here so that would be my focus, especially the hot PTU description, did it come with an adapter harness? If I remember correctly it’s not a straight swap.
The CAS also looks like it’s slammed over, do you put back in the position it came out from?

By Stephen · 7 hours ago7 hr
Quite Smokey and think it’s misfiring

Not a given but a start;
Blue Smoke, combusted oil.
Grey Smoke, Uncombusted oil (turbo rear seals)
White smoke, condensation/coolant.
Black smoke, over fueling.

Turbo smoke if it’s the classic rear seal failure these ones get, is a grey smoke that occurs on warm idle. Did you actually drive the car or just run it up?

By Stephen · 8 hours ago8 hr

Sign In

Race Technology AP-22 Performance Meter

Featured Replies

Join the conversation

Recently Browsing 0

Recently Browsing 0

Popular Posts

UK TT Manual Project

Quite Smokey and think it’s misfiring

cranks but wont start Nissan 300zx z32 1990

cranks but wont start Nissan 300zx z32 1990

Quite Smokey and think it’s misfiring

Important Information

Account

Navigation

Search

Configure browser push notifications

Chrome (Android)

Chrome (Desktop)

Safari (iOS 16.4+)

Safari (macOS)

Edge (Android)

Edge (Desktop)

Firefox (Android)

Firefox (Desktop)