I'm trying to do the rear wheel bearing on my zed and i cant remove the hub. I have used a puller, and i have hit the crap out of it. Is there something im missing? I have looked on the 300zx on line manual but it doesn't really help. Can anyone give me some advise? Has anyone done a step by step guide?

 

Thanks sarah

Have you undone the four 19mm bolts and the 27mm nut on the back of the hub.

 

Paul

Hi yes they are removed. I cant see anything else that i can undo or take off

when I took mine off the splines had some corrosion on them, yours may have the same, try some wd40 or similar but you probably done that already.

 

Paul

Have you unbolted it from all the link arms. This may not be necessary.

Edited May 29, 200916 yr by 300_zedx

Hi yeah ive used wd40. The link arm and wish bone and drive shaft are all attached to the hub carrier this is all free standing on the bench. Sarah

Then it has to be stuck on the splines, so you either need a press or you could use some heat but you will have watch the rear seal if you don't have a new one.

 

Paul

Yeah i think im going to have to get the complete hub and drive shaft as its not going to move.

You could try in the wanted section someone may have one on a breaker.

 

Paul

Thanks for your help. I have posted on the wanted section and hopefully someone will have one. Sarah

Not much help really, you seemed to have all the base's covered.

 

Paul