After a bit of a delay due to work commitments, I’ve finally dropped my block off at OCS engineering to rework a donor block I sourced from Banzai Breaker a few years ago.
They’re confident they can make the needed adjustments to make sure the billet main caps fit properly and the correct size!
Can’t imagine it’ll be done this side of Xmas, but at least I’ve finally made a start!
By
nickz32 ·
Hi all,
long story short, loads of vibrations through the car, found the centre bearing to be at fault. Then notices that both U/J's are notching too.
Any ideas who can recondition these? I've made a few calls but most companies can't do them.
knackered prop = me not a happy bunny!
thanks in advanced
Ad