z500

a big thanks

hi there, i sent my payment last week by bank transfer, was just wondering if its gone through ok and when i might be able to have full use? thanks dan

hi there, just to let you know i sent my money by transfer yesterday. just let me know when it arrives thanks.

cheers mate, had a feeling it would be that. any idea how tough it is to do? thanks

hi all, i have a problem with my clutch. after sitting in traffic and pressing up and down on the pedal alot the biting point got higher and higher. and it also went rock hard :D any help would be gratefully appreciated.

i tried disconnecting the stock boost sensor and it worked! for about 3 minutes. it drove up and down the road fine. i was chuffed but as i pulled back in bang there goes the fuse again. wtf is going on. very confused any thoughts? Daveman

hi mate thanks for getting back to me. could you be more specific on the location of this solenoid and what does it do? thanks again

i have recently installed a rebuilt engine in my 90tt manual. she runs fine at standstill but as soon as i pull away the ign con fuse blows in the engine bay relay box. its the 10amp one. i have checked and checked for trapped wires, bad earths and even tried tilting engine and box and yanking on loom/connections and nothing. but soon as i pull away bang the fuse goes. was gonna disconnect the alternator and try and drive it then????? any ideas???

thats what i thought but i double checked when i did mine and its just a bit of crap design. the shorter ones barely reach into the thread when they tighten up.

same thing happened to me. stupid f*****g design bolt doesnt reach very far into block as it tightens up so theres alot of leverage on a small amount of thread. it was a pain but easy to fix. i think the helicoil was a WURTH one. and i used the same gaskets and there was no probs. good luck

ahh, i have no reception in my village. give us a ring tomorrow sometime. dan

07721765956

you can give me a call if you want to talk about parts and prices. i am doing a 600 ish hp rebuild at the mo and can give you a good idea where to get parts and how much to pay.dan

just have a good look in and around, dont think the heads are too bad just got to be careful not to catch valve seats. i would thoroughly recommend porting out the exhaust manifolds aswel because there even more restrictive than the heads. if you look inside them youll see what i mean, lumps and bumps everywhere. you can use the same tip for them but high speed as its cast iron. also trim up the gaskets for the new bigger ports when you fit them otherwise it will all have been a waste!!!!!! give us a shout if you want to ask anymore.

that exactly what i did!!!!!!