stixman

Thanks for clearing this up for me.

Hi guys recently purchased a decated stainless steel with exhaust to replace my tired one. When I had a look at it, I realised that it did not have anywhere to fit the 2 O2 sensors that are fitted near where the cats used to be in the exhaust.Can anyone tell me if the engine would be affected if these sensors are not fitted.Sorry if this question sounds stupid but I can't figure out why a company would sell these exhaust without provision for these sensors.:detective:

Hi Dave thanks very much for your help but I have a problem. The colours on the plugs of my series 2 ptu don't match the ones on yours. The part number is different 2202097E00,bought it on ebay.Can you please tell me the how to wire it by quoting which colour wire from the loom go to PTU pins E1 to E6 and pin 1,2,3,G,4,5,6 of the other plug.Sorry for being a pain in the ass.:headvswal

Thank you very much Dave,was getting very depressed walking pass my 300zx everyday and getting into a 1.4i Honda Civic:bow::dance:

Hi guy I hope you can stop me hating my 300zx.It won't start and there is no spark from any of the plugs.It had a series one ptu but I figured I should get the series 2 ptu to avoid the situation again. Can anyone tell me how to rewire my loom to take the series 2 ptu. I have series 2 connectors ready to be soldered on.Please help me :bowdown :bowdown

Since you sold me your lame donkey of a 300ZX saying that your mechanic says it only needs fuel injector connectors to cure misfire,you refuse to take my calls.How interesting is it to actually find you on this site telling the truth,it would have been nice if you had told me that you had bypassed the det sensor. I would suggest no one buys a car from this con merchant. He lives in Newcastle and not Ireland as is stated in his profile.You sad little man:nono: