Andy Puttick

if it is a small pin prick hole try cutting it out and rejoining with a 8 mm compression joiner, it worked for me and was still holding after 2 years. just check that it is 8 not 10 mm it`s been a few years since i did anything on a z.

[a ttach=config]114586[/attach][attach=4589[/attach]

The lot to be collected in one go,not willing to split or sell separately.

HIDS4U lighting kit brought last year but never fitted still new and never been out of box,has new slim ballast resistors. Makes a huge improvement to dipped beam.

Drivers side sill return brought from Z World last year but never fitted,includes postage

d.t.a. conzult diagnostic kit complete with dell latitude laptop all set up and working very well.

I think that car was for sale in a garage near Arundal West Sussex a couple of years back finished up in a garage in Fareham Hampshire.Look very carefully if it is the same car may not be as good as you think probably find the engine bay is very different colour for a start.

cat back exhaust,thought to be power flow in very good condition

cat back system fits N.A or T.T. not sure of make but thought to be power flow very good condition as shown in photos[ATTACH=CONFIG]82960[/ATTACH][ATTACH=CONFIG]82961[/ATTACH][ATTACH=CONFIG]82962[/ATTACH]

wanted manual aircon control pod for 1996 t.t Andy Puttick