In rides At last.

Very nice mate, but WTF is that Manual gearknob :rofl:

Im working on it, lol

Im working on it, lol

 

Could use that as an attraction in Amsterdam, you'd make a fortune :D

Lol, its not screwed down properly either. Goes down about 15mm or summint.

Got the wrong thread cut. Its some made up crap.

Think its a bit big too, but get her back on the lathe and munch it up some more.

Lol, its not screwed down properly either. Goes down about 15mm or summint.

Got the wrong thread cut. Its some made up crap.

Think its a bit big too, but get her back on the lathe and munch it up some more.

think it should be a M10 thread bud. but you knew that LOL..

 

its about time you got some pics up :slap: :tongue:

 

 

btw wheres the cat paw prints gone :wack:

Lol, I gave it a wash.

 

Its not M10x1.5 or M10x1.25 or M10x1.

 

I have found that a 3/8 BSF tap goes down the gear nob, but it wont screw on the gear stick. Its 10 thou over size. So probably going to have to run a 3/8 BSF die nut down the gear stick to take the 10 thou off.

 

Then hope I dont screw it up, lol....

 

 

Also going to make another gear nob as that one is too big.

Lol, I gave it a wash.

 

Its not M10x1.5 or M10x1.25 or M10x1.

 

I have found that a 3/8 BSF tap goes down the gear nob, but it wont screw on the gear stick. Its 10 thou over size. So probably going to have to run a 3/8 BSF die nut down the gear stick to take the 10 thou off.

 

Then hope I dont screw it up, lol....

 

 

Also going to make another gear nob as that one is too big.

i made mine see my rides section. i could have sworn that it was m10 coarse :headvswal sorry bud way a while when i made it LOL

Put some thread gauges on and checked in zeus book. Only matched to 3/8 bsf.

Gotta say, i never tried coarse, but it def dont look coarse.

Will check it out.