It was all going so well - albeit I knew there had been a slight misting of fluid on top of the NSF coilover strut..... And when Jim put the Zed on the ramps to sort the new track rods ends, speed sensor etc,. that coilover gave up....!!
Luckily it happened whilst the car was still at Powerzed!! Jim recommended a set of HSD coilovers from Driftworks - I ordered them on Tuesday and they arrived yesterday, ready for him to fit.
It might be there a few more days than anticipated, but it will be coming back much better than before; in more ways than I originally expected😄
By
RichardS ·
Apparently, there are three different sizes, the largest (mine) being 1 1/16" bore, though I don't know the other sizes.
Also apparently, this size was only used for about a year. (Info from Cassicar automotive)
So the question is, what year or chassis numbers had the 1 1/16" BMC?
Could anyone do me the favour of checking theirs (the size is cast on the barrel) and helping me plumb the depths of Nissan's parts system?
Oh, it's on a 200SX before anyone suggests the obvious! :)
Cheers chaps,
Billy.