Hiya, i'm new around here and joined for information and also advice into how i should go about dealing with my Z.
I bought this Z a few months back with a relatively unknown history, the only real info i had was that the engine was rebuilt in the last 5 years or so, has atleast a few minor mods (radiator, BOV, potentially turbo stuff?) and that the car ran decently well.
i've come to self diagnose that my knock sensor is knackered, my speed sensor either has a bad ground, worn out or needs a solder fix in the dash(0-5mph wiggle upon being stationary occasionally), and due to the 5~ years since an engine rebuild i think the timing belt + tensioners require doing just for peace of mind (the cars only done 4k miles since the rebuild)
i'm more electrically inclined than mechanically inclined so i wanted to ask for any reccomendations for shops that are familliar with z's to fix my knock sensor and change the belt + tensioners and to perhaps have a quick look over the general state of parts on the car. The only place i know of is PowerZed but its quite a trek (which i guess isn't the end of the world if y'all reccomend that as the place to go).
By
Z32 Enjoyer ·
Ok after 3 years the engine is back and all plumbed in. Had a quick fire up tonight has a misfire and will not idle.
So going to spend the next 2 days to get it running and sounding how it should.
Also just installed a PTU S2 and does not have a air filter yet? was lost in the post again!!
So the question is where should I start?