Pistons and rods installed. Just waiting on a set of STDX King rod bearings to make some adjustments to my big end bearing clearances…. Unsurprisingly, the STD size bearings EPR used produced 0.0017” clearance not the 0.0035” quoted in the build sheet. Targetting 0.0025” for this build. Also reinstalled the @brettdempseyengineering oil tree. Oh and I will never use a ratchet piston ring compressor ever again, these ring compression sleeves are SOOOOO much easier to use!!
By
nickz32 ·
following on from the meet here
http://www.300zx.co.uk/forums/showthread.php?t=86954
the next one is 2/4/07 at the J30 M4 toby carvery again, kick off 7:30, hoping for better weather and a good show of Z's :D