Chrome bonnet lifter - brand new

Followers

August 3, 201511 yr

I have a chrome bonnet lifter that I bought off CeeJay ages ago that I won't use. This is brand new and never been fitted.

Sadly, the fitting kit has got lost somewhere so this is only the strut itself that is available. CeeJay might be able to supply the relevant fittings to go with it...

Looking for £15 delivered to your door :)

August 3, 201511 yr

You have pm

August 3, 201511 yr

Has it gone I will take it if it's not gone.

August 3, 201511 yr

I'll have it

August 3, 201511 yr

Author

Richie has first refusal on this, guys - just waiting for him to read his PM :)

August 4, 201511 yr

Author

PM sent...

Edited August 4, 201511 yr by Mondo

August 4, 201511 yr

I'll Paypal u dosh

Sent from my iPhone using Tapatalk

Followers

Go to topic listing

No registered users viewing this page.

No registered users viewing this page.

Project Black Sunshine - The 300bhp NA

Back to TDI for the RaceCal tune. Ran into the same problem we had with the last motor (before it went bang), loss of hp above 6K. Power builds really well to that point and if it continued at the same rate it is likely I will hit my 300bhp target at 8K. Consensus is that my exhaust system is not flowing well enough so header research and new cat back system is next. Good news is engine is solid, with fueling and spark behaving perfectly. I always knew a fast NA would be a challenge!

By madmarco · 1 hour ago1 hr
New member (UK)

Hiya, i'm new around here and joined for information and also advice into how i should go about dealing with my Z.

I bought this Z a few months back with a relatively unknown history, the only real info i had was that the engine was rebuilt in the last 5 years or so, has atleast a few minor mods (radiator, BOV, potentially turbo stuff?) and that the car ran decently well.

i've come to self diagnose that my knock sensor is knackered, my speed sensor either has a bad ground, worn out or needs a solder fix in the dash(0-5mph wiggle upon being stationary occasionally), and due to the 5~ years since an engine rebuild i think the timing belt + tensioners require doing just for peace of mind (the cars only done 4k miles since the rebuild)

i'm more electrically inclined than mechanically inclined so i wanted to ask for any reccomendations for shops that are familliar with z's to fix my knock sensor and change the belt + tensioners and to perhaps have a quick look over the general state of parts on the car. The only place i know of is PowerZed but its quite a trek (which i guess isn't the end of the world if y'all reccomend that as the place to go).

By Z32 Enjoyer · 8 hours ago8 hr
Project Black Sunshine - The 300bhp NA

Swinging through and checking up on your progress! Everything still behaving as expected? What's the word on the tune?
-Cheers

By protoj · 10 hours ago10 hr
New Series 4 Remote

Ive got one of those, came with my vert but never worked, asumed it go broken when aftermarket alarm was fitted

By ianl · 10 hours ago10 hr
NEC 2026 - your club needs you!!

I could probably make this if needed

By ianl · 10 hours ago10 hr

Chrome bonnet lifter - brand new

Featured Replies

Recently Browsing 0

Recently Browsing 0

Popular Posts

Project Black Sunshine - The 300bhp NA

New member (UK)

Project Black Sunshine - The 300bhp NA

New Series 4 Remote

NEC 2026 - your club needs you!!

Important Information

Account

Navigation

Search

Configure browser push notifications

Chrome (Android)

Chrome (Desktop)

Safari (iOS 16.4+)

Safari (macOS)

Edge (Android)

Edge (Desktop)

Firefox (Android)

Firefox (Desktop)