Pistons and rods installed. Just waiting on a set of STDX King rod bearings to make some adjustments to my big end bearing clearances…. Unsurprisingly, the STD size bearings EPR used produced 0.0017” clearance not the 0.0035” quoted in the build sheet. Targetting 0.0025” for this build. Also reinstalled the @brettdempseyengineering oil tree. Oh and I will never use a ratchet piston ring compressor ever again, these ring compression sleeves are SOOOOO much easier to use!!
By
nickz32 ·
went out last nite, started at 6 down the local then went to another town (chester le street) drank there for a few hours then back to sunderland
didnt get in till 3.30 pm
my feet are killing me (trying to dance lol) and my eyes are a pale yellow color, but the worst part is im £100 lighter
but enjoyed every moment of it, cant wait for the next ladsnight out
what did you's do last nite